Leaderboard AdX

December 23, 2010

Tip #3 - Autodesk Inventor Slot Axis Tutorial

Here is a tutorial explaining how to add a axis in the center of a slot so you can add fasteners easily to the center of the slot in Autodesk Inventor 2011.


Hope you find this useful.

Posted by jdits7
Labels: , ,

1 comment:

  1. AnonymousOctober 11, 2011 at 11:08 AM

    You can also view sketch, then add "normal to plane through point" work axes through the sketch center points on each slot.

    ReplyDelete

Note: Only a member of this blog may post a comment.

Subscribe to: Post Comments (Atom)