AUGI Inventor Wish List Results. Hope some of your wishes made it into the top ten.
- Highlight Underconstrained parts in assembly - Highlight parts and sub-assemblies in the browser that are not fully constrained.
- Allow coping grouping of parts maintaining constraints - If while in an existing .iam file, I have let’s say three parts that I place into my .iam file and then I constrained them together as a group, I would like to be able to copy them and paste them still constrained together.
- Add right click short cut for applying constraints - Add right click short cut for applying constraints, when finished, allow right click, then select done, complete, finished,.... rather than going back to dialog box and click cancel.
- Create BOM based on Level of Detail within an Assembly - Create a Parts List/BOM based on a selectable Level of Detail on the associated assembly, .iam. When the dialog box opens to create the BOM, option box to check if you want to select the LOD, if not, do nothing, use Master. If so, un-gray the LOD listing and select which one to use.
- Allow customization of the iProperties table - Allow customization of the iProperties table, configured as needed by individual companies.
- When mousing over a feature, have the related feature in the feature tree highlight - When mousing over a feature, have the related feature in the feature tree highlight, this enables in selection for editing.
- True Text Editor - Have a true text editor in Inventor.
- Remember Open File Dialog Size - I would like Inventor to remember the size of my "Open File" dialog box and my "Open from Vault" dialog box.
- Model Browser Bar, Filter, Selection for invisible parts/components - Allow for single selection to make all invisible parts/components visible. Much quicker than selecting each part and selecting visible.
- Add option for Materials to carry over when derived parts are made of them - Add option for Materials to carry over when derived parts are made of them, as well as adding the option for individual materials based on the which Solid is selected.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.